This is a very simple rolled brim hat knit on double-pointed needles. It has quite a bit of stretch to it to accommodate growth, and the rolled brim allows parents to roll the brim up or down to fit their baby perfectly. It’s the perfect hat!
Download the PDF version here!!
Never used DPNs? Don’t be scared! Once you figure it out you’ll wonder why you never tried it before! Here and here are two Youtube videos that might help you learn. You can either cast on all your stitches to one straight needle and then divide them between your 3 dpns, or you can cast on directly to your dpns while making sure to divide your stitches evenly (this is my preferred method). Feel free to ask me questions if you get confused!
NOTE: Make sure to measure your gauge and adjust appropriately! As I’ve mentioned before, I tend to have a tighter gauge than the average knitter.
Materials:
- Worsted Weight Yarn (I used Knit Picks Chroma Worsted Yarn in “Galapagos”)
- Size 7 DPN’s
- Tapestry Needle for weaving in ends
Abbreviations:
- DPNs: Double-Pointed Needles
- k: Knit
- k2tog: Knit Two Together
Gauge:
2″x2″ = 10 stitches x 15 rows (stockinette stitch)
Size:
0-6 months (6-12 months, toddler)
Pattern:
Cast on 70 (80, 90) stitches, distributed evenly between your three DPN’s.
Knit every row until your hat measures approx. 4.5 (5.25, 6) inches from the cast-on edge.
Begin Shaping Top:
Round 1: *k8, k2tog* (repeat around)
Round 2 and every alternating round: knit
Round 3: *k7, k2tog* (repeat around)
Round 5: *k6, k2tog* (repeat around)
Round 7: *k5, k2tog* (repeat around)
Round 9: *k4, k2tog* (repeat around)
Round 11: *k3, k2tog* (repeat around)
Round 13: *k2, k2tog* (repeat around)
Round 15: *k1, k2tog* (repeat around)
Round 17: *k2tog * (repeat around)
Finishing Option 1:
Continue knitting in the round on your 7 remaining active stitches (make sure to keep your stitches as tight as possible so your needles don’t slip out — the less stitches, the harder it is to keep them on there) until your “tube” measures approx. 3 inches. Cut your yarn, leaving about a 10 inch tail, and thread it through your active stitches using your tapestry needle. Pull the end through the top of the hat (this is why we left the tail so long — so it can make it through the whole “tube”) so it’s on the inside (wrong side) of your hat, then pull tight to close the hole. Loop you “tube” around in a knot, getting the knot as close to the top of the hat as possible, and pull tight. Cut the tail left on the inside of your hat, and weave in any ends you may have.
Finishing Option 2:
Cut your yarn, leaving about a 6 inch tail, and thread it through your active stitches using your tapestry needle. Pull the end through the top of the hat so it’s on the inside (wrong side) of your hat, then pull tight to close the hole and weave in your ends. Leave the top smooth or add a pom-pom.
